Team Chevelle banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
547 Posts
Discussion Starter · #1 ·
Earlier I had asked a question concerning finding the torque specs for things like exhaust manifolds and such. I got a response to check the Haynes manual, which I happen to have. Anyway, in the manual it says to torque the exhaust manifold bolts to 20 ft lbs, and the inner to 30 ft lbs on a 350 CID. I have the 350 CID, but when they say inner do they mean.....

My attempt at the exhaust bolt pattern......

AB CD EF GH

Are B, D, E, G the inner bolts? I know this may seem trivial to some, but just want to do this right.

Thanks,




------------------
JR
TC #1098
My 69 Convertible

My 2001 Z28



[This message has been edited by jerryr (edited 12-07-2001).]
 

·
Registered
Joined
·
547 Posts
Discussion Starter · #5 ·
I never doubted there was a reason for the difference, I just wanted to make sure I understood which ones were inner and which ones were outrer. That said, are there only 2 inner and the other 4 are outer?

Thanks

------------------
JR
TC #1098
My 69 Convertible

My 2001 Z28
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top