Pick up a stock L78 intake. It works fine on oval port heads despite what people might think. The car will look more or less factory stock.
Need advice on BB intake - 67
Rebuilding the 396 - actually a '70 402 in my 67.
The aluminum intake is garbage - pitted inside - poor quality - and the 650 Edlbrock is too small. Have to replace both. Probably get a 750 carb.
Street cruiser, 402 will be about 400 horse when done. Nothing crazy.
What have you used for an intake and carburator combo that fits under the SS hood of a 67 ? I checked the Performer RPM Air Gap on Summit and it said NO FIT to corvettes and 65-67 chevelles.
Recommendations? I like my bigger air cleaner look and would rather not have to buy the low profile one.....
The aluminum intake is garbage - pitted inside - poor quality - and the 650 Edlbrock is too small. Have to replace both. Probably get a 750 carb.
Street cruiser, 402 will be about 400 horse when done. Nothing crazy.
What have you used for an intake and carburator combo that fits under the SS hood of a 67 ? I checked the Performer RPM Air Gap on Summit and it said NO FIT to corvettes and 65-67 chevelles.
Recommendations? I like my bigger air cleaner look and would rather not have to buy the low profile one.....
1 - 1 of 6 Posts
1 - 1 of 6 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
