Team Chevelle banner

Need advice on BB intake - 67

871 Views 5 Replies 5 Participants Last post by  meesh
Rebuilding the 396 - actually a '70 402 in my 67.

The aluminum intake is garbage - pitted inside - poor quality - and the 650 Edlbrock is too small. Have to replace both. Probably get a 750 carb.

Street cruiser, 402 will be about 400 horse when done. Nothing crazy.

What have you used for an intake and carburator combo that fits under the SS hood of a 67 ? I checked the Performer RPM Air Gap on Summit and it said NO FIT to corvettes and 65-67 chevelles.

Recommendations? I like my bigger air cleaner look and would rather not have to buy the low profile one.....
1 - 1 of 6 Posts
With a drop down base for the air cleaner, an Airgap or the RPM will fit under a stock 67 hood. I have a 66 with that setup and if you do a search on this board you will find a lot of others with the same setup.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.