Chevelles.com banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Gold Founding Member
Joined
·
1,347 Posts
Discussion Starter #1
A few years back in one of the magazines in the back there was a place you could get plans for a test stand it had gauges and a radiator I know they can be purchased complete but I have access to welding equipment and prefer to build my own Thanks Mike
 

·
Registered
Joined
·
42 Posts
mike, the one i've seen was a engine cradle with a bracket for radiator, gas tank and battery. shouldnt be too hard to fab up, just use a dummy block as a jig so you get the motor mounts right.
 

·
Super Moderator
Joined
·
12,693 Posts
Mike,
We have a "store bought" run in stand that works pretty good. I will try to take a picture or two of it and send them to you. It may take me a while as I just started a new roll of film in the camera, so be patient.
BillK

------------------
Bill Koustenis
Advanced Automotive Machine
Waldorf Md
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top