Team Chevelle banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
97 Posts
Discussion Starter · #1 ·
SS 396.com has a mounting kit for a console for my 70 chevelle. Is it necessary? Are there holes or dimples in the floor board to line up the console and shifter? Can I just put sheet metal screws through the plastic holes at the bottom of the console? Any advice is appreciated.
 

·
Registered
Joined
·
100 Posts
The mounting hardware is necessary. The brackets should be tack welded to the tranny tunnel, giving the console several "flat" spots to bolt down to. Steve

------------------
1970 Chevelle Convertible
 

·
Gold Founding Member
Joined
·
64,241 Posts
when I added an automatic console to my 70 the only thing I had to buy was one bracket that I welded on for the rear of the console

There were dimples to mark the location for all the other necessary holes

------------------
Dean Call
Team Gold member #3
A.C.E.S. # 00235
Mid America Chevelle Club #001
chevelles.net
My 69

ACES/Midwest Chevelle Regionals


A soft answer turns away wrath, but a harsh word stirs up anger.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top