Motor Mounts

672 Views 5 Replies 4 Participants Last post by Tom Mobley, Apr 27, 2011

gstubble

Discussion Starter · Apr 26, 2011

I have a 66 and am putting my engine in. It seems to be rotated slightly. My header collectors are about 2 inches different in height causing the right side to not allow installation of the extension pipe due to it hitting the transmission crossmember. The frame was from a different car and it had a 6 cylinder in it. Do I need to drill new holes in the crossmember for the brackets or what? Any help is greatly appreciated.

Save

1 - 1 of 6 Posts

Tom Mobley

· #6 · Apr 27, 2011

The Hookers on my car hang down over inch lower on the drivers side. the engine is level. I have seen several other examples of hookers like this.

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Home
Forums
Mechanical
Engine
Motor Mounts

Top Contributors this Month