Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I just spent the best part of the day helping
a freind install a new Edelbrock performer
manifold and Edelbrock carb on his 67' El Camino.After installing all the new stuff and
making sure everything was hooked up right and tight we fired it up.It fired up fine,we
let it warm up set the idle mixture and timing.At this point it was time for a test drive(not!!).The car just would not run,off idle under load.After checking and rechecking all the basic stuff It was time to pull the air horn off the carb to check the float level and much to my suprise one of the primary venturi boosters was missing.I've always been a Holley tpye guy.I think this might change my buddys mind.Lots of wasted time and effort on poor Q.C.Who would'a thunk.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top