Team Chevelle banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
How tight do I want to get the imput shaft adjusting nut on my 4 speed? I just got done rebuilding it and this is the last thing I need to do before I put it back in my 67 Chevelle.
 

·
Registered
Joined
·
12,948 Posts
I don't think you can go too tight (unless you twist off the shaft). Using the special input nut wrench, I always give it all I can (which definitely is over 40lb). Don't forget to stake the nut.

------------------
Tom Parsons
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top