Team Chevelle banner
1 - 2 of 2 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
on a '66 hardtop.
but i need help installing the rear panels.
when i pulled the old ones out two years ago (in several pieces), i really couldnt take note on how they were installed. i kept them though.
im looking at my new ones, and i know i must cut out the holes for the arm rests and window crank.
but there is quite a bit of extra vinyl material sticking off the front and rear edges about an inch. there are a few holes in certain places through the extra vinyl edges.
im wondering how i should set it, cut it, wrap it, however its supposed to be.

im guessing some windlace is supposed to go on the edge of the door jamb, possibly holding/snugging up to the rear panel?

thanks for any help you can give me.

------------------
Lucas
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top