Team Chevelle banner

Inner/ outer whelhouses 66

679 Views 3 Replies 3 Participants Last post by  Kaizen
Question for you guys doing or have done a 66. I'm in some final line up stages on the rear. I've run into something I need an opinion on. On the inner wheelhouses fitment, If I lift the wheelhouses up to the factory brace. I come up short on metal to weld them to the trunk floor. If I lower them I need to lower the brace/ bracket. What have you guys done if you have ran into this issue.

1 - 2 of 4 Posts
I've got goodmark pieces. I've rotated and moved them around to try and find the "sweet" spot were they will fit decent. If I get them to fit the floor fairly nice, i have an area at the trunk brace that is not covered at all, and than I can't make the brace on the upper portion to weld to.
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.