Team Chevelle banner
Cancel

I have a issue with A arms and springs! Help

1457 Views 5 Replies 5 Participants Last post by  myrusty66, 
A
Hi all, I have a 66 BB 396 that I have 90% restored. The front drivers side seems to "sag". The front "leans" towards the drivers side. So today we took the Springs out to check everything out. The bushings are new and in place the shocks are new and the springs are new BB springs (OPGI). The A Arms are original. When we took the springs out it they were not seated correctly in the upper control arm so we set it correctly in the upper. But then the lowers were off on both sides. Is that normal? Are Control arms BB/SB specific? Are shocks BB/SB specific? I'm at a loss. The front also when turning feels like it is "floaty"
It is original steering box, can I tighten it up?

Thanks for the help!
Mike
Reply
Save
Like
1 - 1 of 6 Posts
M
The bushings are new and in place the shocks are new and the springs are new BB springs (OPGI).

There are earlier posts about people getting mismatched sprinngs from OPGI and having the same issue with one side sagging.
Reply
Save
Like
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Bench Racing Performance Engine Body Shop Chevelle Tech
Top