Team Chevelle banner
Cancel

How to Properly Paint Aluminum Water Pump?

2006 Views 3 Replies 4 Participants Last post by  Chevyrelic, 
B
Okay, I have a new aluminum water pump that I would like to paint chevy orange. What are the prep steps to paint the pump? Do I use rough up the surface then use a solvent to clean it or is there a special prep to use on aluminum? The guy at Jegs said not to use solvents on aluminum but soapy water instead but the paint guy at the body shop store said to use a good degreaser after sanding such as PPG's DX330. Who is right?

Thanks in advance for your input.
Reply
Save
Like
1 - 1 of 4 Posts
C
I would add that I masked off the shaft and weep holes before I sprayed mine. A few minutes spent masking these areas will ensure that it turns out real nice for you. Nothing worse than a mad spray bomb artist...:D
Reply
Save
Like
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Bench Racing Performance Engine Body Shop Chevelle Tech
Top