Team Chevelle banner
1 - 1 of 1 Posts

227 Posts
Discussion Starter · #1 ·
I know I've read on here to put all the mounting screws back in for dome light, headliner, other hardware, etc. before installing the headliner.

My question is has anyone tried using a pencil point soldering iron for "melting" the holes in the product.

My logic is that this would create a more fused and round hole that would be less likely to "tear" out. Maybe all the hardware anchors it enough that this is not an issue.

Anyone tried it? What do you think?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.