Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part May's Ride of the Month Challenge!

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
79 Posts
Discussion Starter · #1 ·
Guys I am working on the drivers side header for my 65 454 SS. I can't get the car high enough with the jacks and jackstands that I have.....I am looking at the steering shaft and it looks like if I jack the engine and remove the shaft I could plunk it in from the top like I did the passenger side. What do I have to do to get that shaft out of the way and has anyone tried it this way and what were your results? Thanks. Headers are Hooker comps with a 2 inch tube...they fit the passenger side like a glove and look like they will fit the DS fine if I can just get it in there.

------------------
Bill
65 SS
Team Member 1013
 

·
Registered
Joined
·
425 Posts
1 - 3 of 3 Posts
Status
Not open for further replies.
Top