Team Chevelle banner
1 - 8 of 8 Posts

· Registered
Joined
·
648 Posts
Discussion Starter · #1 ·
Hey guys,
what is the best way to get to Bremerton from the Lynnwood/Everett area? The crappy headers that I have sit kind of low in the front and I am not sure if this will pose an issue with the ferries...

Is the Seattle - Bremerton ferry the best way?

thanks
 

· Registered
Joined
·
5,147 Posts
I would get to the gates at 2 o clock if you are going through bremerton even on the freeway by it can get a little backed up after 3.

Both ways are gona take you about the same time. I think for you going to the edmonds kingston ferry then driving down would be the best.(I think lynwodd is just right next to edmonds right?) Plus you can probably meet a couple of the guys from the group taking that ferry and just tag along with them down to bremerton.

If you do take the seattle bremerton ferry though the track is about 10-15 miles from the boat.
 

· Registered
Joined
·
648 Posts
Discussion Starter · #4 ·
Edmonds is 10-15 minutes from here....I was going to catch an early ferry and get to the other side of the Sound around 1 or so, grab some lunch and head over to the track...

Have been trying to figure out how to transport some decent tires on this thing, I have the Nitto 555Rs on it now, but they don't do much....don't have room in the car for a second set of wheels, tires, jack, tools, et cetera so I might get some Hosiers and drive with them to the track...

it has been 3-4 years since I have been to the Bremerton track, but I think I can find my way...

thanks guys...
 

· Premium Member
Joined
·
5,454 Posts
I'll drive around but I have to be through Everett by 12:30 to miss the traffic. Any later and I hit stop and go traffic.

Takes about the same amount of time to go around ot take the ferry. I'll be towing the car going around is fine. If I was driving the car to the track, the ferry would likely be the way I'd go.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top