Team Chevelle banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
585 Posts
Discussion Starter · #1 ·
Anyone have experience with installing fuel cells? The one have have has 2 fitting on the bottom and one on the top. Is the one on the top for a vent or can it be used for a return line with a fuel injection setup? If it's for a vent only, where do you vent it too? There was no instructions with this fuel cell!

Lee
 

·
Registered
Joined
·
1,451 Posts
mine has 1 on bottom where i run braded AN10 line from to a filter then to the pump, the top is a vent that should have a "LOOP" in the tube then out the bottom of the trunk, see pics of mine below. somewere on my site
id think the return line on the bottom with the out line.

------------------
1970 SS396 AKA 454/4spd
My Chev-Hell Page
Member #783
Ft.Worth, Tx
Big Block Chevy.net
proud owner of this site
(oo|ss|oo)
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top