Team Chevelle banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
485 Posts
Discussion Starter #1
Is there a difference between the left and right front spindles? I have them off of the car and am not sure if I remember which one goes where. I have noticed that the bolt hole pattern for the wheel cylinder is different between the two. Anyone know for sure?
 

·
Registered
Joined
·
71 Posts
Is this a 70 Chevelle? I am guessing it is by your user name. If so, both spindles are the same. The wheel cylinders bolt to the backing plates, not the spindles.......GT
 

·
Registered
Joined
·
485 Posts
Discussion Starter #3
Yes, this is a 70. I guess I should have also included that the backing plates and hubs are still attached to the spindles. Are the left and right sides still the same in this case? Thanks
 

·
Registered
Joined
·
71 Posts
Guess I didn't understand your original question. Both spindles are the same but the whole assembly is not . Put the assemblies on so the wheel cylinder line fitting point rearward so your brakehose will run behind the spindle.........GT
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top