Team Chevelle banner

Floor pan on a convertible

1540 Views 15 Replies 4 Participants Last post by  1badss396
I purchased a full floor pan with braces and rockers from ground up and I am about to lift the car off the frame I welded cross braces in each door and I cross braced the windshield frame to the rear wheel tubs Is there any other place I should brace before lifting the car or cuting the pan out I was gong to leave the old rockers in place
1 - 3 of 16 Posts
If you need the frame chart to check it for sag or twist here it is.

See less See more
OMG thank you That will be a great help
Your welcome. Just ask the questions some one here will be sure to answer your questions.:yes:
68-72 A Body
1 - 3 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.