Team Chevelle banner
Cancel

external slave for tremec

1405 Views 5 Replies 5 Participants Last post by  chupf, 
T
fellas,
I have a 72 that I've installed a 383 with a quicktime bell and a tremec tko 600,I've also installed a hyd clutch system consisting of a firewall mounted master and a tob slave,(99% sure its a ram clutch product)works great except my slave is now leaking from the internal orings,i want to install an original type tob and pivot arm,which I have.What I would like to do is install an external slave,so I need a mount and a slave and never visit this leak again,any idea what I need?thanks
Reply
Save
Like
1 - 1 of 6 Posts
C
15020 Lakewood bell with either size flywheel or 84-92 F-body bell (only takes 153 tooth)
If you go 153, the inner starter bolt needs drilled in the right place & countersunk if you don't have it already and the right starter.
The McLeod adapter plate (Fortes carries it.)
84-92 or 93-97 F-body or some Cavalier slave (slight differences in i.d.)
Appropriate extended pilot bushing.

This all hedges on your exhaust clearance of course.
Reply
Save
Like
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Bench Racing Performance Engine Body Shop Chevelle Tech
Top