Team Chevelle banner

Either I'm nuts or Chevy made a change!

1322 Views 7 Replies 6 Participants Last post by  Schurkey
I was just looking at the drawing on page 24 in the Factory Assembly Manual for my '64 (section 3, sheet 4.00). It shows the lower and upper A arm bumpers both toward the REAR of the arm. Now, either both my old and new lower arms were installed reversed (is that even possible?), or Chevy goofed in their drawing. Please, tell me I'm not nuts! :confused:
1 - 1 of 8 Posts
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.