Joined
·
166 Posts
Trying to measure for custom Drive shaft in 72 Chevelle. Insatlled Gear Vendor over drive (had to alter cross member) installed Strange S-60 rear end and all new control arms that are adjustable. Talked to drive shaft place today and they say I want 2-3 downward degrees on both rear end yoke and Gear Vendor OD with reference to the Chassis when taking meassurements for drive shaft.
I can adjust both rear end and GV OD but do not know where for reference on the chassis.
I was able to borrow a digital protractor from work that I can 0 at any reference point.
WHAT and where on the frame is the best place to reference ?
I can adjust both rear end and GV OD but do not know where for reference on the chassis.
I was able to borrow a digital protractor from work that I can 0 at any reference point.
WHAT and where on the frame is the best place to reference ?
