Team Chevelle banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
1,063 Posts
Discussion Starter #1
I am redoing an old distributor that I bought and I'm wondering if that's special lube that goes on the shaft inside it. If so, where can I get some??

Also, is 9H13 (August)an acceptable date code for an engine built on November 17, 1969? Thanks!

------------------
1970 Chevy Custom El Camino aka Kaileigh
Green Mist & Silver w/Green Vinyl Top
350ci/300HP 4bbl & Factory Dual Exhaust
Non-SS with Factory Rallies!
TH-350 Automatic - 2.73 Posi Rear
My El Camino Home Page - www.dreamelectric.com
 

·
Registered
Joined
·
12,972 Posts
Shawn,
This is a 3mo lead time on the dist, but it is realistically possible. I'd use it in a heartbeat.

------------------
Tom Parsons
 

·
Registered
Joined
·
1,063 Posts
Discussion Starter #5
I'm glad to hear that.
Well, I just got the distributor back together and lubed it with grease in the shaft (the same grase you put in tie rod ends; the black stuff). Is this ok? I'll be converting the distributor over to the Pertronix system but the grease won't screw up my engine, will it?? Thanks!
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top