Team Chevelle banner

Cutting in floor pans

786 Views 1 Reply 2 Participants Last post by  malibu356
My first floor pan job, does this procedure seem correct. I plan to overlap the pans so should I sand down the overlap area to good metal. Apply weldable primer to the overlap area, have my pan cut and plug weld holes drilled, apply seem sealer to overlap area and then plug weld thanks Chuck
1 - 1 of 2 Posts
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.