Team Chevelle banner

Cowl Induction Experts Please!

1620 Views 4 Replies 4 Participants Last post by  Sean
I'm completely restoring my cowl induction system as part of my engine resto and there is one part I cannot find mention of anywhere in our catalogs - and being a purist I want the correct part. There is some type of screw which holds the outer cowl door to the vacuum actuator pod. None of the catalogs, YearOne, GroundUp, NPD, OPG, etc. make any mention of this "screw". When I asked our sponsor they assured me it was the same shoulder bolt as is used for the outer door hinges (the ones with the nylon bushing) but this is incorrect as the diameter of the hole in the outer door isn't wide enough. Can anyone help??? I can easily rig it with a pin screw but I know its not correct. Thanks in advance if you can answer this!

Stan Hanek
'71 SS - 454 4 sp.
Not open for further replies.
1 - 1 of 5 Posts
hey stan, Nice 71, it looks exactly like my 72, Ill send a pic.
I used a screw with the same thread size, i'm not sure if it is correct but it works fine and you dont see it.

Jeff litka
72 chevelle SS
72 Montecarlo

[This message has been edited by JSL (edited 02-18-2001).]
1 - 1 of 5 Posts
Not open for further replies.