Thanks for the info. I'll try the water separator route mounted several feet down the line and see how that works.
Scott
Scott
Compressor, Water Separators, Rubber Line
Fellas -
Did a few searches and found some info on setting up hard lines in a shop/garage from the compressor to the tool end. My problem is that I'm active duty military, and will only be here for 1-3 more years, so I'm not inclined to plumb the garage with hard lines.
My setup right now is a 33 gallon 6 hp Sears compressor and the flexible rubber hose. I use it to run air tools, blast cabinet, and may try to paint with it, too. Right now, the water in the line does slow down the blasting process a bit.
Any info/ideas on where/how to minimize moisture in the rubber line?
Thanks!
Scott
Did a few searches and found some info on setting up hard lines in a shop/garage from the compressor to the tool end. My problem is that I'm active duty military, and will only be here for 1-3 more years, so I'm not inclined to plumb the garage with hard lines.
My setup right now is a 33 gallon 6 hp Sears compressor and the flexible rubber hose. I use it to run air tools, blast cabinet, and may try to paint with it, too. Right now, the water in the line does slow down the blasting process a bit.
Any info/ideas on where/how to minimize moisture in the rubber line?
Thanks!
Scott
1 - 2 of 5 Posts
1 - 2 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
