Team Chevelle banner
1 - 2 of 2 Posts

· Registered
183 Posts
Discussion Starter · #1 ·
Has anyone ever tried "manufacturing" an in dash clock (for say a 1968) by using a a craft store clock movement?

I was thinking I could just drill a small hole in the delete plate and insert the shaft of the "kit" clock through that hole. Then the delete plate could be the clock dial.

Does this sound dumb/crazy?

John W.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.