Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part May's Ride of the Month Challenge!

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Sorry guys, this may sound like a stupid question, but here goes. Got my bb427 back from the shop with all the freeze plugs installed except for the large rear cam plug. What should I use to seal it? Should it be driven in flush with the block? Any advice appreciated, thanks, Brad.
 

·
Registered
Joined
·
85 Posts
I like to drive them in just past the chamfered edge, about 1/8 " in. I use red loctite around the edge to seal them.

Ken
 

·
Registered
Joined
·
214 Posts
I use that permatex indian head stuff, duno if its the best or not though

[This message has been edited by ratlover (edited 08-22-2001).]
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top