Team Chevelle banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
I'm putting together a 454 and i need cam help it's going in a 72SS convt. I'm try to the make it as close to a ls6 or ls7, go with a stock ls6 cam or something else? I want good street power with that can be driven
thanks
dave
 

·
Registered
Joined
·
341 Posts
You didn't mention what you want to use this for, what compression ratio, what cylinder heads, what trans, what gear. Driving a car on the street with 11:1 pistons is cool in my book, but then again $3.00 plus per gallon of gas can get into your wallet big time! Ls6 and ls7 are super motors, but I would have to think that there are much better cams designs available today than were twenty years ago when those motors were new. I called Crane and used their recommendation on my 454 and am very happy!
 

·
Registered
Joined
·
12 Posts
If you want the specs on the LS-6 or the LS-7 send me an e-mail and I will pull out my book. I have an LS-6 that I just rebuilt and I made sure I had all of the specs correct before I did it.

Scott [email protected]
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top