Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part May's Ride of the Month Challenge!

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1,033 Posts
Discussion Starter · #1 ·
What does this look like? where does it attach? Does it go underneath the bumper? Mine is missing this entirely, if someone could e mail me pics of it installed i would greatly appriciate it... i imagine its the same setup on 68-72 elkys.
 

·
Registered
Joined
·
177 Posts
I don't have a picture of the piece but I have seen them in different catalogs. Its as wide as the tail gate and maybe 2' wide. On my Sprint when you open the tail gate at the end of the bed and down about 2" there is about a 3/4" lip just barely below the bumper with about half a dozen 1/4" square holes in it for the seal to attach to. Hope this helps!!!

------------------
Tom Donaldson
71' GMC Sprint
 

·
Registered
Joined
·
95 Posts
joey, on my '70, it's made of black rubber, runs the length of the tail gate and is about 5" wide. it attaches with steel clips on the body below the tailgate(you can see the square holes for the clips. you can buy it at most of the chevelle parts places.

------------------
jim #899

68 SS396 CHEVELLE CONVERTIBLE
70 SS396 ELCAMINO


cars, guns & guitars.....& beer...
it doesn't get much better than that.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top