Team Chevelle banner

Brake bleeding, 70SS

883 Views 5 Replies 5 Participants Last post by  1badss396
I have read a few posts (search) on this issue but not sure what applies to a 1970, so need yr help.

First,this is a full resto, reconditioned, but all original components and new steel brake lines....I cannot get brake fluid to the back drums. I assume the proportion valve (cleaned) is the culprit and somehow needs to be reset or adjusted.

I am using a hand bleeder vac pump that pulls the air and fluid out. I also tried it w/o the bleeder pump, same result. Front disc's bled out just fine. Thanks.
1 - 1 of 6 Posts
You should have started with the brake farthest from the master,passenger rear when doing all new lines.
After you get fluid there the rest are a breeze.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.