Borg Warner Super T-10 information please...

2171 Views 5 Replies 3 Participants Last post by 136679ss, Mar 27, 2007

baddbob71

Discussion Starter · Mar 27, 2007

I need to know the correct yoke length for a Super T-10 transmission. I sent my Son's T-10 off to get rebuilt awhile back and think I got someone else's yoke back by mistake. From what I remember the yoke I had originally was quite a bit longer than the one I have now and I'm a little worried if I run the short one I might have some bushing problems if it isn't right. I've been browsing the internet trying to figure out what yoke this trans calls for but can't seem to find any info. Ebay is offering numerous yokes that say they fit the TH400, Muncie and T-10 but I really think there is a length difference. Does anyone here know for sure if the T-10 takes a specific length yoke? Are there length differences? Thanks in advance for any info, or links, Bob

Save

1 - 1 of 6 Posts

Gary Anderson

· #2 · Mar 27, 2007

http://www.drivetrainspecialists.com/categories/slip-yoke/products/product-2465.html

It seems there are 3 lengths from center of cup to end: 5.5", 6.75" and 8". I guess you could use any as long as your driveshaft is the correct length and the right size u-joint.

I currently have the short 5.5" one in my Super T-10 and it is fine. The yoke is the same length as the 27 spline one it replaced when I swapped out my Muncie for the ST-10.

The bushing in the trans is about 1"-1.25" wide and it sits about 1.25" deep in the tailhousing. So anything over 2.5" in the tailhousing is beyond the bushing. I have one of the 6.75" yokes I got by mistake and it will go into the trans all the way without hitting anything inside.

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month