Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
currently building a 454 to install in a 64 malibu ss . just curious has to how tall of a intake manifold will fit before having to cut the hood . cutting the hood in my mind is not an option . i have the 850 double pumper already but havn't purchased the intake.
 

·
Registered
Joined
·
56 Posts
ddd, i had the same issues with my 66(396). I purchased an edelbrock RPM manifold & was told that I would have some height problems.
I'm using a major drop base & still can only use a 2" air cleaner... Even that is close to the hood.
Also, i would not be able to use a plate under the carb either, so if the super juice is in my future, I better find a nice cowl hood!

Good Luck with it!
Jake

http://www.ecsi.net/homedir/jake/
 

·
Registered
Joined
·
38 Posts
Jake,
nice website,Is that you being a wheel barrel? I particularly like the scrolling slide show. never seen that done before.
Nice looking chevelle, looks like your almost riding.
waive
 

·
Registered
Joined
·
56 Posts
Waive,
Thanks for the review... Still trying a couple things yet...
That pic is from the movie The Hollywood Knights, by far the best car movie out!
As for the car, I'm definitely anxious to drive it!!

Jake

------------------
Tubby's Drive In
http://www.ecsi.net/homedir/jake/
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top