Team Chevelle banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Gold Founding Member
Joined
·
978 Posts
Discussion Starter #1
i bought one from sears thinking that would mak it easy to adjust timing...but there is a rigd on the manifold which wont allow the wrench to go down far enough to engage the bolt so this wrench is useless...

what tools do you BBC guys use to get on this squarely so as not to round the hex??

who is supplier? where?? how much if you remember?

------------------
Rich
Cocoa Beach, Fla
Team Chevelle #380
[email protected]l.com
www.chevelles.com/showroom/70_SS_454.jpg
 

·
Administrator
Joined
·
16,196 Posts
Try a different brand,I use a K-D Tool # 104 and it fits every engine I used it on so far. The 9/16" side has a step in it and just enough offset to fit most manifolds. The Ford/Mopar side is just offset.

------------------
Philip Valentine
Lakeside, AZ
Gold Member #42
"Perseverance is not a long race; it is many short races one after another."
[email protected]
 

·
Registered
Joined
·
13,015 Posts
Philip is on the money, there are SEVERAL configurations of dist wrenches on the market. Check several sources, including NAPA.

------------------
Tom Parsons
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top