Team Chevelle banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
4,763 Posts
Discussion Starter · #1 ·
Hi guys:
My aluminum bellhousing has been cut to allow clearance for the starter. I have been told that this is because it is for a small block.
If it was out of the car right now, I could take measurements for comparison, but it isn't...how do I determine if I am looking a BB bell housing vs a SB if shopping at a swap meet?? Is there a specific measurement or ID# or?? TIA.

------------------
Ron Cook TC Gold Member #1276
1969 300 Deluxe HTSS396 69 300 Deluxe 325HP L35 69memorylane
1971 Malibu 2DR HT
"Supporting all car guys, even those with different cars than yours, is what being an enthusiast is all about."
 

·
Registered
Joined
·
4,763 Posts
Discussion Starter · #4 ·
Thank-you guys!! Tom, you truly are a wealth of knowledge! I guess I need a new starter at some point then...
-R
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top