Team Chevelle banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
203 Posts
Discussion Starter · #1 ·
I've got my coupe (70SS LS6) on a lift and have been measuring the frame to ground distance along both rails. My drivers side frame rail is 1/2" lower at the back (near the tank) and gradually comes to equal at the front spring.

Is there a way to shim the rear spring with a 1/2" spacer to bring the rails level? Is there some other way to do this? I don't think the frame is bent because of the way it gradually decreases from 1/2" to level.

Any help/comments are appreciated.


Thanks,

RLK
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top