[dblvenom]

Completing the restoration of my 1970 SS which was built the last week of September 1969. Does anyone have the correct measurements of the belts by location in the car. I have 5 female belts and three male. The original male shoulder belts are in place. I believe I am short two female belts. Any help would be greatly appreciated.
Thx

 

[861_ford]

u require three female and three male for the rear .
with front buckets, u require 4 female & two male (seat belts) besides the shoulder harness.
with bench seats, u require 5 female & 3 male (seat belts) besides the shoulder harness.

 

[Tampa Jerry]

You should have seven sets of belts. Three sets for the back seat. The back seat will have lap belts only. The front should have four complete sets. Two of the sets are for lap belts and the other two sets are for the shoulder harness(s). The shoulder male belts will have double bolt holes for mounting on the roof into a boss behind the headliner. The two male belts on the front will be attached to the retracter just inside each door. The other three male belts go to the floor behind the rear seat and attach with a single bolt. Hope this helps. Jerry