Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part August's Ride of the Month Challenge!
1 - 4 of 4 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
I purchased new rear seat covers from someone on this site. The covers are in new condition but I decided not to use them. The reason is that the roll and pleat is flat instead of the stock puffed up roll and pleat. Does anyone make them identical to stock?
 

·
Premium Member
- Ben R. - Snohomish, WA
Joined
·
7,855 Posts
Take a look at the inside of the covers you got for a tag sewn into one of the seams-

Does it say "Distinctive Interiors" or does it say "PUI"?


I ordered a set of covers from OPG for my 69 about a year ago & had them installed. They were flat just as yours are... Mine were produced by "Distinctive". I have heard that the "PUI" brand covers are a little more correct- but still flatter and less puffy than the origonals were..
 

·
Registered
Joined
·
4,942 Posts
I have PUI's in mine. They are 'puffy' The originals were in it and over the years had become hard and dirty. The originals 'seemed' flater than the new PUI's, I just chalked it up to age. One thing I don't like about the redone seats is the foam. Too much and too stiff. If I ever rip it apart, I'll remove some of the cushion foam.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top