[NOTHINBUT69s]

Does Anyone Have The Specs On Installing The Fender Ss 396 Emblems On My 69? When I Got The Car It Only Came Withh The Nos Fenders So I Dont Have The Templet. I Would Like It To Be Pretty Close To Same Spot They Were From The Factory. Thanks Jim

 

[Mike72ss]

Here is a picture from our SuperMod Dean's website, showing his 69's emblems. Great job Dean!

Mike

 

[NOTHINBUT69s]

Thanks Mike, This will help alot. Jim

 

[Hal_396]

Great scoop there. If we could get someone to take mearsurements like that just for the holes, that would be GOLDEN!

 

[lakremer]

Mike, Thanks a bunch for the SS fender info. I'm ready for the drill now

Larry

 

[Mr69]

Be very careful when drilling by hand. If there is any filler, the drill bit will wander and you'll be drilling the holes in the wrong spot. Don't ask me how I know this.:sad:

Start with a very small drill bit, then drill from the backside. Make sure you have some very sticky tape over the hole to keep the paint from chipping.

 

[rubadub]

Another way to drill it from the out side, put two layers of masking tape a few inches beyond where you will be drilling, or even a foot wide, and start with a small bit like Nate said.

You lay out your lines on the masking tape, and if the drill bit goes sideways, your covered.

Rob