Interesting question Kevin. I would say it all depends on where the vinyl top was cut. If it goes down in the gutter and then up again on the lip - then yes, the "spread" on that molding would be too wide. If the vinyl top was cut to end at the bottom of the gutter - then they should be the same.
I have no idea where the vinyl top cut should be made, hopefully somebody can jump in here for you. Otherwise, you might want to post this in the "Body Shop" section.
Good luck.
------------------
ACES #4241, TC #947
69 SS Sedan
CanAm Chevelle Club
I have no idea where the vinyl top cut should be made, hopefully somebody can jump in here for you. Otherwise, you might want to post this in the "Body Shop" section.
Good luck.
------------------
ACES #4241, TC #947
69 SS Sedan
CanAm Chevelle Club
