[texasc5]

I have a turn signal and flasher question. I have built a new dash with analog gauges for my 67 chevelle. I have re-used as much of the existing wiring loom as possible. After putting it back together my turn signals will work with the key off. I did not touch the turn signal wiring except for replacing the dash lamps with LEDs. I used the pink wires to power the gauges and the grey for lights. Does anyone know where I can find a good diagram for the turn signals? I have one for the general wiring. Any ideas why this is happening? My brake lights and tails work fine. The right front and left rear turn are not currently working. Also the left dash light works only when the key is on. The right one does not. I would appreciate any help I can get.

 

[Gary56]

A guy on ebay sells color wiring diagrams for $20. It's pretty good imo, better than the black and white diagram in my service manual. I'd suggest starting with that and see how far you can get. Sounds like you may have gotten a B+ feed switched with an accessory feed, or maybe one terminal touching another at the light switch, ignition switch, or fuse panel/bulk head connector. I don't know, I'm no wiring expert.

 

[1Fast7D]

Does anything else work thats not supposed to when the key is off?

Most likely your backfeeding the circuit from the rewire. Take the turn signal fuse out, does the turn signals still work?