[sbubby]

finally got the 396 dropped without the exaust manifolds now we cant seem to get them to go in im sendin a link to the ones i purchased. do you have to remove the steering column to get them in we are frustrated and finished for the nite thanks for all the help

http://cgi.ebay.com/ebaymotors/ws/e...d=1,1&item=4578169477&sspagename=STRK:MEWN:IT

 

[EddieC67ss]

That's because the are for a full size Chevrolet, will not work on a Chevelle. I see so many ebay auctions that list these type manifolds for a Chevelle. Get your money back.

 

[sbubby]

does anyone have the correct casting for 67 exaust manifolds i know or where maybe i can get a good set thanks

 

[EddieC67ss]

3892307, 3909880 are two used in 67. If you aren't worried about originality they make pretty good repo's

 

[htm]

I had the same problem with mine,, I bought a set at Carisle that was suppose to fit...Wrong I searched evilbay for weeks ended up buying a repo set from Ground Up...... fit and appreance... A+ (for repops) imo..

 

[EddieC67ss]

The only problem with the repos the pass side is for later built 67's and up.

 

[sbubby]

but the repo passanger side will still fit correct thanks

 

[EddieC67ss]

Yes it will.

 

[sbubby]

still debating what about headers im sure there are some that will work any info on a good set thanks

 

[EddieC67ss]

Here we go again "Fits Chevelle" Numbers look familiar.

http://cgi.ebay.com/ebaymotors/1966...586657456QQcategoryZ42606QQrdZ1QQcmdZViewItem

 

[Herb]

Dynomax Ceramic coated is a reasonably priced set of full headers. There are also headers that resemble the old "rams horn" manifolds that feed a 2 inch down pipe.

Anyone else?

 

[sbubby]

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=4578169477&category=34203