[Dansk]

I'm pulling my hair out trying to get the cardboard glovebox back in after installing my dash. I cannot push it in through the front and also cannot seem to wiggle it up from the backside. When I removed it the AC ducting wasn't there but I replaced all that now. Yes I do have the version designed for an AC car. Any ideas? At least tell me which direction it should go in from. The door is removed. Thanks

 

[blm]

Unbend and remove enough staples to allow the liner to partially collapse. Put it in place. Unfold liner and reinstall same staples. Bend staple legs over by hand.

 

[Dansk]

I got it, thank you blm. I also found it easier if I allowed the pass side AC vent to hang out of the dash while I wrangled it into place. The repro cardoard box I bought had to be trimmed back a little around the duct because there was excess material outside the staples. Ughh, that was difficult to do with a sinus headache today.