Team Chevelle banner
1 - 7 of 7 Posts

·
Premium Member
Joined
·
852 Posts
Discussion Starter · #1 ·
PLease see my attached photo with pointers to two of the slots under the hood that I think should have rubber bumpers. I'm wondering what the rubber bumpers look like and orientation of them. I think I have them but don't know what goes where. Thank you. Hood Automotive lighting Steering wheel Vehicle Automotive design
 

·
Registered
1966 Chevelle SS396
Joined
·
883 Posts
That's where the steel lines for your windshield washers go.
Edit: The slot in the cowl panel is where the washer line goes. Not sure about the one on the fender.
 

·
Registered
Joined
·
122 Posts
Yes, as aztec66 mentioned, your bumpers go there. Here is what my original looks like (sorry for the crappy peeled paint). I tried to pull it out to give you a better pic but I don't think I can remove it in one piece!

Leg Automotive tire Wood Automotive design Motor vehicle
 

·
Premium Member
Joined
·
4,693 Posts
You should have a rubber seal that runs the length of the cowl. It seals the cowl to the hood. Look at the left side of ronaldinho66's pic above.
 
1 - 7 of 7 Posts
Top