Team Chevelle banner
1 - 10 of 10 Posts

· Registered
Joined
·
3,845 Posts
The chevelle and elcamino use the same replacement panel.Never had a wagon but would think they are the same or close because the rear seat is the same place as a chevelle and they all have the same wheel base.
 

· Registered
Joined
·
276 Posts
I think that all 64-65's pans are interchangeable. Mine are 65 2door sedan pans front and rear. Get the full pan and save some hassle. I bought four separate pieces and reused my trans tunnel. At that time only the two sides were available, not tunnel. A one piece would be 1000X better looking and far easier to install. Looking at this has me seriously thinking to redo it!

Talk to the people at ground up. They will confirm this.

http://www.ss396.com/mm5/merchant.m...egory_Code=FLOORPAN&Store_Code=chevellecamino
 

· Registered
Joined
·
36 Posts
64 through 67 wagons all use the same floorpan and firewall for all A-body cars. The only part different is the flat cargo area you can even use a buick olds pontiac floor for a donor floor if you dont want to spend the big buck on repo junk :hurray:
 

· Registered
Joined
·
4,522 Posts
64-67 all A-bodies the same.
For those working on 68+ wagons, ElCaminos, and 4dr cars-----you can most likely
use the 64-67 floors, as any differences will be very minor.

68+ 2dr cars are 4" shorter in the rear seat pan
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top