5.5" Series Delcotron

503 Views 3 Replies 3 Participants Last post by Johnny_pugh, Nov 25, 2003

Johnny_pugh

Discussion Starter · Nov 24, 2003

I have disassembled my alternator 69 Malibu 6cyl engine) cleaned all the parts and have started to reassemble. How the heck does the brush assembly go together ? . If the springs are installed under the brushes, there is no room to place them on the stator rings when the stator is placed into the field windings. There are no suggestions in the Chassis Shop Manual.
Thanks for any suggestions
John

Save

1 - 1 of 4 Posts

Dean

· #3 · Nov 25, 2003

Use a straightened out paper clip or similar piece of wire through the hole in the brush holder, out through the hole in the back case to hold the brushes in place.

After assembly, pull the paper clip out.

Save

1 - 1 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.