Thanks Don! You just confirmed what I thought. I will take a better look at it tonight. The poor driveshaft hasn't been connected to the car for over 20 years.
2004R to driveshaft yoke engagement
I have a question about fitting my old drive shaft into a 2004R I just put in. My car is a 66 Chevelle that had a Turbo 350 before the swap. When I place the yoke into the 2004R, it only goes in about 2 inches-it that normal for a 2004R? If its suppose to go in further, than what is the trick? I don't want to cut the shaft unless I really have to. Any information would be great.
Thanks!
Thanks!
1 - 2 of 3 Posts
1 - 2 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
