2000 Camaro Trans question

1772 Views 7 Replies 3 Participants Last post by JIM, Aug 10, 2009

JIM

Discussion Starter · Aug 9, 2009 (Edited)

Buddy of mine has an 2000 Camaro stick shift. I assume a T5. He needs to pull the trans for a clutch change. Is this a standard removal process or does the bell have to come off with the trans as a unit? He says he has the 4 bolts out of the trans that attach it to the BH, but it is held up by some TO bearing linkage?? It think it is part hydraulic/part cable. How does the trans come out of one of these things??

Save

1 - 4 of 8 Posts

JIM

Discussion Starter · #3 · Aug 9, 2009

Re: 2001 Camaro Trans question

Hey, thanks for the reply. he sent me the pic below. I'm not sure what the (1) and (2) are. But he said the white collar slid in easily. I guess it is inside of the brass colored collar in the picture. But he says he can not get the silver braided line out of the brass connector. Looks like he had some pliers on it by the scratches. Is that where it is supposed to separate?

See less See more

Save

JIM

Discussion Starter · #5 · Aug 10, 2009

Re: 2001 Camaro Trans question

OK, I will have him try pushing the collar in at the same time he is pulling the line out to see if that helps. So the part with the (1) pointing at it (scratched up brass piece) will come out of the larger diameter brass piece? Or does the braided line with the crimped on fitting come out of that scratched up brass piece?
Thanks for the help.

Save

JIM

Discussion Starter · #8 · Aug 10, 2009

Re: 2001 Camaro Trans question

Thanks guys!

Save

1 - 4 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month