[waterwalker]

Does anyone have a pic of the transmodulator hard line routing from carb to trans? Can't seem to figure it out...the new line doesn't seem to layout right.

 

[LeoP]

No, but it doesn't go to the carb, but rather a fitting on the manifold.

 

[70-SS454]

That's a fact jack....

 

[waterwalker]

Spoke with InLine Tube, since the assembly manual only shows a Turbo 350 application , and they didn't have an immediate answer for the hard line they sold me..so I'll ask again anyone have a pic or assembly drwg. for the Turbo 400?

 

[Ark68SS]

This is off of a '68 car and assembly manual, but a '70 ought to be similar.
Here's a pic of the manifold fitting where the pipe goes in.

I'm not sure about a '70, but page A4 of Section M40 in a '68 assy manual says in box #1 "Parts & installation same as RPO M35" for the assembly of the modulator pipe.

Page A18 in Section M35 is shown below-

BillL