Team Chevelle banner

1970 Swap

2291 Views 14 Replies 4 Participants Last post by  Tyoung
Ok so long story short..my 1970 Chevelle was a factory 4 speed..previous owner put a 700r for wife to drive. I replaced the engine ZZ502 deluxe crate. Runs great but now decided to go back 4 speed.

Ive already got with Paul at 5speeds and have my M22 on the way.

I didnt want to try to piece the rest together since it will be a fast turnaround on the swap i went to a few different vendors ebay etc.. and finally just said hell with it and narrowed down to OPGI / Ground up..am i missing anything on these quotes? any advise would help..thanks

Clutch Linkage Kit - 1968-72 Ch/EC, 1970-72 MC
Quantity: 1
SKU: CL111AB
Unit: Each

64-81 CHEV 11" BELLHOUSING
Quantity: 1
SKU: CH26684
Unit: Each

HAYS CLUTCH THROWOUT BEARING-PERF.
Quantity: 1
SKU: C210256
Unit: Each

CHEV CLTCH ROLLR PILOT BEARING
Quantity: 1
SKU: C210258
Unit: Each

14" OD 168 TOOTH FLYWHEEL
Quantity: 1
SKU: CH20330
Unit: Each

10.5" CLUTCH KIT 26 SPLINE
Quantity: 1
SKU: L201286
Unit: Set

68-72 CHV/EC MUNCIE SHIFTER
Quantity: 1
SKU: C210263
Unit: Each

69-72 CHV/EC MUNCIE INSTAL KIT
Quantity: 1
SKU: C210268
Unit: Each

Console TOP PLATE, 4 SPEED 68-72 Chevelle-El Camino
Quantity: 1
SKU: 9508031
Unit: Each

68-72 4SPD CONSOLE BOOT
Quantity: 1
SKU: PZ0078
See less See more
1 - 1 of 15 Posts
Here are some parts you might need.

Frame bracket bolts
Boot retainer
Retainer bolts
Steering column bracket
Steering column bracket foam
"G" Clips
NSS
NSS Wire
Ball Stud
Inspection plate
Inspection plate bolts
Starter nose
Shifter bracket on crossmember
Flywheel bolts
Pressure plate bolts
Bellhousing to engine bolts
Transmission to bellhousing bolts
Back drive linkage
Back drive linkage bolts
Pedal bumper
Shifter boot hold down

I couldn't bring up the shifter and install kit on OPG site to see what else is needed. The shifter boot is for a non-console car. I agree with Jody you will need the 11" clutch.
Russ
See less See more
1 - 1 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top