1970 Heater control valve ???

2991 Views 9 Replies 4 Participants Last post by Donnie1, Jan 5, 2006

Donnie1

Discussion Starter · Dec 19, 2005

how is the heater control valve supposed to be attached to the inner fender?
is it riveted on or screwed on.
and does anyone have pics of the correct fasteners.

thanks Donnie

Save

1 - 4 of 10 Posts

richr

· #2 · Dec 19, 2005

Donny,

Mine was screwed on - I also had a different type then most, it was the orig one - had a tough time finding one just like it.

Thks

Rich

Save

richr

· #3 · Dec 20, 2005

Wow - just noticed this on e-bay - this is the one on my car .

http://cgi.ebay.com/ebaymotors/ws/e...=8022864970&rd=1&sspagename=STRK:MEWA:IT&rd=1

Rich

Save

I don't think all plants used that type, I know mine was original, there is even a special end on the vacum line that hooks up to it that will not work with the pancake one. I have only seen a few other A/C Chevelles like that.
In any case I bought mine from a place in TX 4 yrs ago, at the time they had two left. Just for the heck of it I called them, they still had the other one, the last one. Needless to say I bought it, paid 65.00 - will keep it as a spare.

I'll try and remember to snap a pic and post it with the screws. You can just make them out here - can copy this pick to your p.c. and blow it up - may see it better.

Rich

See less See more

Save

richr

· #8 · Jan 4, 2006

Donnie,

What's your e-mail address -or e-mail me @ [email protected] - I'll e-mail it to you

Thks

Rich

Save

1 - 4 of 10 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month